OpenKey Hardware (BLE Modules)
      Back to home
      1. Help Center
      2. OpenKey Hardware (BLE Modules)

      MODULE - Replacing an OpenKey Universal BLE Upgrade Module on a SALTO lock

      MODULE - Replacing an OpenKey Universal BLE Upgrade Module on a SALTO lock

      Print

      Tools

      • Allen wrench set
      • Philips screwdriver

       

      From the backside of the lock or inside of the room, retract the screw holding the handle to the spindle with an Allen wrench.



      With an Allen wrench, screw in the bolt on the bottom of the cover plate, holding pressure to the back cover. Remove the cover.


       

      The module will be on the bottom side of the lock under the handle. Disconnect the module, replace it with the new unit. If the module is not there, continue to next step.  



      Disconnect the orange sensor connector and the red and black power connector from the lock board. Then, with an Allen wrench, remove the top and bottom bolts holding the lock together.  



      Pull the lock apart, and the module will be behind the lock. Disconnect the module, and replace it with the new unit.  


      Follow the same steps in reverse order.


      Program and test the module. If you need assistance with programming, please contact Support@OpenKey.co.